Log in to the Unified Access Gateway administration console (at https://uag-intranet.corp.local:9443/admin).

1. Enter admin for the username.
2. Enter VMware1! for the password.
3. Click Login.

Under Configure Manually, click Select.

Under Advanced Settings, click the gear icon for Network Settings.

1. Click the dropdown arrow for NIC 1: Internet facing interface.
2. This section shows all of the configurations associated with NIC 1.
3. Click the Gear icon after NIC 1: Internet facing interface to update the IP address.

The Unified Access Gateway administration console allows you to update some of the network settings for each NIC. In this step you will update IPv4 address associated to NIC 1.

1. Click the IPv4 Configuration section to expand it.
2. Enter 192.168.110.151 in the IPv4 Address to update this from 192.168.110.150.
3. Click Save.

After saving, a message appears: NIC1 configuration in progress. This means that the Unified Access Gateway is updating the NIC with the new IP address, and restarting the NIC. Users lose connectivity with the administration console and this message disappears when the configuration is finished.

After the configuration completes, click Close.

The page should automatically reload to https://192.168.110.151:9443/admin after the appliance configuration updates, which is the IP address you configured.  You may also enter the address manually.

NOTE: The appliance may take several minutes to be reachable at 192.168.110.151 after the change.  You may need to wait several minutes before the below page will load.

1. Enter https://192.168.110.151:9443/admin and press ENTER, or wait for the page to reload.
2. Click Advanced.
3. Click Proceed to 192.168.110.151 (unsafe).

NOTE: Notice that the connection is not private again, since we are browsing to an IP instead of our previous hostname.  This is just to demonstrate the IP address change, so continue to the page for now.