Introduction

This module will guide you through the GUI based deployment and configuration of the Unified Access Gateway OVF in the vSphere Web Client.

The manual provides steps for deploying one Unified Access Gateway Appliance in vSphere using ONE NIC deployment, make use of Administration Console to configure certificate and change network settings.

This manual covers Unified Access Gateway 3.3 deployment in vSphere 6.5 U1.

Prerequisites

All of the following pre-requisites are already installed for this Module, the following information is just for your reference.

To deploy Unified Access Gateway using vSphere Web Client, you must use specific versions of VMware products.

  • vSphere ESXi host and vCenter Appliance.
  • Download a version of Unified Access Gateway virtual appliance image from VMWare. This is an OVA file e.g. .euc-unified-access-gateway-3.X.X.X-XXXXXXXXXXX.ova. Refer to VMware Product Interoperability Matrices to determine the version to download.
  • You must select the vSphere data store and the network to use.

Starting with version 3.3, you can deploy Unified Access Gateway without specifying the netmask and default gateway settings in Network Protocol Profiles(NPP). You can specify this networking information directly during deployment of your Unified Access Gateway appliance.

0 Comments

Add your comment

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.